Bilge Valve Arm

Discussions & announcements

Moderator: bobassel

Post Reply
GPA2196
Posts: 274
Joined: Mon Dec 12, 2005 9:47 pm
Contact:
Contact GPA2196

Bilge Valve Arm

Post by GPA2196 » Thu Nov 09, 2006 4:23 pm

Gentlemen,

On the passenger side floor where the bilge valve control arm comes through (to switch from front to rear pickup) there are screw holes. Was there a leather boot or something to seal that up... similar to the PTO. Two of my floors I checked both have the holes, so I think its original.

Does anybody have a picture of what is supposed to be there?

Thanks,
Tony
Top
bobassel
Site Admin
Site Admin
Posts: 463
Joined: Mon Dec 12, 2005 10:29 pm
Contact:
Contact bobassel

bilge lever

Post by bobassel » Fri Nov 10, 2006 7:00 am

Yes Tony

That is for a small metal cover plate.
I'll try to make a picture of it.
Take a close look at your pictures you got from me!

Bob
Ford GPA 12350, april 2nd 1943
Author of GPA book,
Willys MD M38A1, A13817 1952
Top
bobassel
Site Admin
Site Admin
Posts: 463
Joined: Mon Dec 12, 2005 10:29 pm
Contact:
Contact bobassel

bilge valve cover plate

Post by bobassel » Fri Nov 10, 2006 7:01 pm

Image
Ford GPA 12350, april 2nd 1943
Author of GPA book,
Willys MD M38A1, A13817 1952
Top
GPA2196
Posts: 274
Joined: Mon Dec 12, 2005 9:47 pm
Contact:
Contact GPA2196

Post by GPA2196 » Sat Nov 11, 2006 10:33 am

Thanks again Bob!
Top
Post Reply

Return to “Amphibian Jeep ford GPA g504”

Who is online

Users browsing this forum: No registered users and 27 guests