Page 1 of 1

Perfect double lip oil seals & extra V - seals

Posted: Fri May 19, 2006 6:27 pm
by bobassel
Hello

A tip for you all;
I use , to keep the water out of my GPA bearings & diferential,
special double lip oil seals from "EBELE".
Type; NE 8378. size; 53.98 x 73.04 x9.52 RP.
Image
As extra seal I use V-rings.
S.K.F. ; V-55 A.
Image
Succes! (At my GPA hardly a drop comes in)

Greetings;Bob Asselbergs

Steering lnuckle kit 908226

Posted: Sat Apr 07, 2007 5:52 pm
by bobassel
As an extra for the front axle I use this extra set.
It is a modern CJ 5 knuckle set which is better than the original ones!
South African Owner Eugen Nick used it in (now) my GPA!
The Ex -Mexican GPA of Peter Verhoeven was fitted with
the same seals!
In combination with the dubble lip seals and V-seals it is a
perfect way to keep the water out of your front axle.
The number is ; 908226 for two wheels.
Image
Bob

Posted: Fri May 25, 2007 10:28 am
by jerome
Dear Bob

Thanks for your posts on oil seals. Would you by chance have a list of recommandation for all oil seals of the GPA (modern references like for SKF seen on two posts).

Thanks

Jerome

Bearing list

Posted: Sat Jun 02, 2007 1:44 pm
by bobassel
Jerome & others

On the site of Cees Witte there is a bearing list.
http://www.filmprops.nl/produkten/fordgpa.htm
Sorry that I didn 't answer sooner but I just forgot it! :oops:

Bob

Posted: Sun Jun 03, 2007 8:30 pm
by jerome
Dear Bob

This is an outstanding work youy did. So helpful! Thanks a lot

Now I still have a few questions. On the TM, I saw those seals (or related)

Front axle
GPA 3135
GPA 1089
GPA 1018

PTO
GPA 7246
GPA 7257
GPA 7262

Propeller
GPA 4477 (mentionned on your list, but no available source)
GPA 4459

Do you have any idea where to get those

Thanks

Jerome

Bearings & seals

Posted: Tue Jun 05, 2007 9:22 pm
by bobassel
Jerome

There are here in Holland several adresses were this problem can be solved.
You must have the original bearing or seal and take this to this shop or adres.
I 'm sure there is a sollution for your problem.

Bob

Posted: Wed Jun 06, 2007 8:09 pm
by jerome
Thanks Bob

I did it here for my GPA, I took it to a shop where they adapt metric seals to the GPA parts.

Again, thanks a lot for the amazing job of putting the list together.

Cheers

Jerome